Frigidaire FFBD2406NB9B Dishwasher Operation Manual

The Frigidaire FFBD2406NB9B is a 24-inch built-in dishwasher in black finish, featuring Precision Direct Wash System for efficient cleaning. It offers multiple wash cycles, energy-efficient motors, and options like Hi-Temp Wash and Sani Rinse. Ideal for residential use, it handles up to 14 place settings and is compatible with standard household plumbing and electrical systems. Below are the key specifications and operation instructions.

Key Specifications

• Type: Built-in dishwasher with Precision Direct Wash System
• Compatibility:
  • Residential use; NSF certified for sanitization
  • Standard 120V, 60Hz household current
  • Water pressure: 20-120 PSI
  • Hot water supply at least 120°F (49°C)
  • Compatible with food waste disposers (if empty)
• Power Source:
  • 120 V, 60 Hz; 15A circuit
  • Individual grounded branch circuit
• Electrical Rating:
  • 15A fuse or circuit breaker
  • 2-wire with ground
• Dimensions: 24" W x 24" D x 33-1/2" - 34-1/2" H (adjustable)
• Features:
  • Wash cycles: Heavy Wash/Pots & Pans, Normal Wash, Upper Rack, Quick Wash, Rinse Only
  • Options: Delay Start (1-10/1-24/2-4-6 hours depending on model), Hi-Temp Wash, Sani Rinse (select models)
  • Capacity: Up to 14 place settings
  • Self-cleaning filter, rinse aid dispenser, adjustable racks, silverware basket, heating element
  • Quiet operation; status indicators (Clean, Dry, Wash)
• Operating Conditions:
  • Water temperature: 120°F minimum (up to 155°F with Sani Rinse)
  • Humidity: Non-condensing
• Wash Cycle Details:
  • Heavy Wash/Pots & Pans: 10.9 gal, 2 1/4-2 1/2 hrs
  • Normal Wash: Up to 8.0 gal, 1 1/2-3 1/2 hrs
  • Upper Rack: 6.5 gal, 1 hr
  • Quick Wash: 5.4 gal, 1 hr
  • Rinse Only: 2.3 gal, 1/2 hr

Operation Instructions

Initial Setup

1. Register Product: Online at frigidaire.com or mail card.
2. Add Rinse Aid: Fill dispenser; adjust 1-6 for spotting.
3. Add Detergent: Based on water hardness; pre-wash for heavy soil.
4. Load Dishes: Scrape food; load properly (soiled sides to spray arms).
5. Check Water Temp: ≥120°F at faucet.
6. First Use: Run empty Normal cycle.
Warning: Do not tamper with controls; keep children away.

Operating the Dishwasher

1. Select Cycle: Heavy for pots, Normal for daily, Upper Rack for glasses, Quick for light, Rinse Only for rinsing.
2. Select Options: Delay Start (set hours), Hi-Temp Wash (heats water), Sani Rinse (155°F, +50 min).
3. Start: Close door; press Start (drains then fills).
4. Interrupt: Open door to pause; close to resume.
5. Cancel: Press Start/Cancel to drain/reset.
Note: Status lights show progress; Delay Start countdown on display.

Care and Cleaning

1. Exterior: Liquid detergent and water; dry.
2. Interior/Filter: Mild detergent; clean filter monthly (rinse under water).
3. Spray Arms: Clean nozzles with toothpick if clogged.
4. Door Gasket: Clean if soiled.
5. Air Gap: Clean if installed.
Warning: Allow heating element to cool.

Troubleshooting

• Won't Run: Door latched? Power on? Cycle selected?
  
• Long Cycles: Normal for heavy/options.
  
• No Fill: Water valve on? Pressure 20-120 PSI?
  
• Poor Drying: Use rinse aid; proper loading.
  
• Spots/Filming: More detergent/rinse aid; check hardness.
  
• Leaks: Check loading/seal.
  
• Won't Drain: Hose kinked? Disposer clogged?
  
• Grinding Noise: Foreign object in pump; clean filter.
  Note: Contact service if persists.

Installation Instructions

Warning: Disconnect power and water; follow local codes; qualified installer recommended.

Remove Old Dishwasher

• Shut off power at breaker and water supply.
  
• Disconnect drain hose, water line, electrical.
  
• Unfasten from cabinet/counter; slide out.
  
• Cap lines to prevent drips.

Installing New Dishwasher

1. Prepare Cabinet: 24" W x 24" D opening; access to utilities.
   
2. Level Legs: Adjust to fit under counter (33-1/2" min height).
   
3. Door Springs: Adjust for balance.
   
4. Route Hoses/Wires: Through cabinet hole.
   
5. Slide In: Align, push fully; connect drain first.
   
6. Level: Front-to-back and side-to-side.
   
7. Secure: Screws to countertop/cabinet.
   
8. Connect Water/Drain/Electrical: See subsections.
   
9. Test: Check for leaks; run cycle.

Electrical Connections

• 120V/15A dedicated circuit; no extension cords.
  
• Connect black to hot, white to neutral, green to ground.
  
• Use junction box or cord (3-prong).
  
• Secure with strain relief.

Water Supply

• 3/8" NPT copper tubing; shut-off valve.
  
• Flush line; connect to inlet with ferrule/nut.
  
• 20-120 PSI; 120°F min temp.
  
• Avoid kinks.

Drain Connection

• High loop or air gap (required by code).
  
• Connect to sink/disposer (remove plug).
  
• Secure clamps; max length 10 ft, min height 32".
  
• No sags in hose.