Frigidaire FFCD2413UB5A Dishwasher Operation Manual

The Frigidaire FFCD2413UB5A is a 24-inch built-in dishwasher in black finish, featuring DishSense™ Technology for automatic cycle adjustment, Precision Direct Wash System for efficient cleaning, and a capacity of up to 12 place settings. It includes multiple wash cycles, High Temp Wash option for sanitization, and quiet operation. Ideal for residential use, it's compatible with standard household plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: Built-in dishwasher with Precision Direct Wash System and DishSense™ Technology
Compatibility:
- Residential use; NSF certified
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit (20A if with disposer)
- Individual grounded branch circuit
Electrical Rating:
- 15-20A fuse or circuit breaker
- 2-wire with ground
Dimensions: 24" W x 24" D x 33-1/2" - 34-1/2" H (adjustable)
Features:
- Wash cycles: Heavy Wash, Normal Wash, 1 Hr. Wash, Rinse Only
- Options: High Temp Wash, Heat Dry, Delay Start (4 hours), Control Lock
- Capacity: Up to 12 place settings
- Self-cleaning filter, rinse aid dispenser, overfill protector, cup shelves
- Status lights: Clean, Cycle progress
- Quiet operation with energy efficient motors
Operating Conditions:
- Water temperature: 120°F minimum (up to 155°F with High Temp)
- Humidity: Non-condensing
Wash Cycle Details:
- Heavy Wash: ~2-3 hrs, 6.7 gal
- Normal Wash: ~1.5-3 hrs, 3-6.7 gal
- 1 Hr. Wash: ~1 hr, 5.4 gal
- Rinse Only: Variable, minimal water

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load racks properly, facing soiled sides toward spray arms; avoid nesting.
2. Add Detergent: Use fresh dishwasher detergent in main and pre-wash cups if needed; close cover.
3. Add Rinse Aid: Fill dispenser (adjust level 1-6 to prevent spotting); light indicates low.
4. Run Hot Water: At nearest faucet until hot, then off.
5. Select Cycle: Press pads; lights glow.
6. First Use: Run empty Normal cycle to flush system.

Operating the Dishwasher

1. Select Cycle: Heavy for heavy soils, Normal for everyday, 1 Hr. Wash for light loads, Rinse Only to rinse.
2. Select Options: High Temp Wash (press Temp pad; heats to 155°F for better cleaning), Heat Dry (for enhanced drying with rinse aid).
3. Control Lock: Hold Options pad 3 seconds to lock/unlock controls.
4. Delay Start: Hold Options 3 seconds for 4-hour delay.
5. Start: Press Start/Cancel; close door to latch. Unit drains briefly, then fills and washes.
6. Interrupt: Open door (pauses); add items, close to resume (within 10 min).
7. Cancel: Hold Start/Cancel 3 seconds to drain and reset.
Note: DishSense adjusts cycle time based on load; normal sounds include drain motor, water splashing, and arm rotation.

Care and Cleaning

1. Filters and Glass Trap: Clean monthly; twist out, rinse under water, remove debris.
2. Spray Arms: Remove and clean nozzles with toothpick if clogged; check monthly.
3. Exterior: Wipe with mild detergent; avoid abrasives.
4. Interior: Run monthly cycle with 2 cups white vinegar (no detergent) for cleaning.
5. Overfill Protector: Ensure it moves freely; clean if needed.
Note: Clean heating element after use if touched; use dishwasher-safe items only.

Troubleshooting

Won't Start: Check door latch, controls unlocked, power supply, no delay active.
Won't Fill: Water supply on? Clean inlet valve screen; check overfill protector.
Poor Drainage: Hose kinked? Disposer empty? Clean filters and air gap.
Soils on Dishes: Pre-rinse heavy soils; use correct cycle and detergent; ensure hot water ≥120°F.
Spotting/Cloudiness: Adjust rinse aid; test water hardness; use less detergent.
Not Drying: Select Heat Dry; use rinse aid; unload promptly.
Leaking: Level unit; check door seal; measured detergent.
Long Cycles: Normal for heating; DishSense adjusts based on load.
Note: If issues persist, contact Frigidaire at 1-800-374-4432.

Installation Instructions

Warning: To reduce risk of fire, electric shock, or injury, read all instructions before installing. Disconnect power and water. Installation requires basic skills; improper may void warranty.

Remove Old Dishwasher

Turn off power at breaker; shut off water.
Disconnect drain hose from sink/disposer; remove from cabinet.
Disconnect water line and electrical.
Unfasten from countertop/cabinet; slide out.
Cap water line; secure hoses.

Installing New Dishwasher

Prepare Cabinet: 24” deep, 23 7/8” wide opening; drill for utilities.
Adjust Door Balance: Check springs for proper tension.
Set Leveling Legs: Extend to fit height.
Route Lines: Water, drain hose, wiring through opening.
Slide In: Partially, connect drain, push fully under counter.
Level: Adjust legs using level.
Secure: Screws to countertop/cabinets.
Connect: Water with elbow, drain to high loop/air gap, electrical.
Test: Check leaks; run cycle.

Electrical Connections

120V, 15A grounded circuit; no extensions.
Route cable, connect white to neutral, black to hot, green to ground with wire nuts.
Secure in junction box with strain relief.
Turn on power.

Water Supply

3/8” copper line; shut-off valve.
Flush line; connect to inlet valve with ferrule and nut.
20-120 PSI; 120°F min.
Check for leaks.

Drain Connection

Air gap or 32” high loop per codes.
Connect to waste tee or disposer (remove plug).
Secure clamps; max 10 ft hose.
Prevent sags.