Frigidaire FFCD2413US Dishwasher Operation Manual

The Frigidaire FFCD2413US is a 24-inch built-in dishwasher with stainless steel finish, featuring Precision Direct Wash System for efficient cleaning, self-cleaning filtration, and ENERGY STAR® certification. It fits up to 10-12 place settings, with heated drying and quiet operation. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

Key Specifications

• Type: 24-inch built-in dishwasher with Precision Direct Wash System
• Compatibility:
  • Residential use; ENERGY STAR® certified
  • Standard 120V, 60Hz household current
  • Water pressure: 20-120 PSI
  • Hot water supply at least 120°F (49°C)
  • Compatible with food waste disposers (if empty)
• Power Source:
  • 120 V, 60 Hz; 15A circuit (20A if with disposer)
  • Grounded outlet required
• Electrical Rating:
  • 15A fuse or circuit breaker
  • 2-wire with ground
• Dimensions: 24" W x 25" D x 33-1/2" - 35" H (adjustable)
• Features:
  • Wash cycles: Heavy Wash (2-3 hours, 6.7 gal), Normal Wash (1.5-3 hours, 3-6.7 gal), 1 Hr. Wash (1 hour, 5.4 gal), Rinse Only (30 min, 2 gal)
  • Options: High Temp Wash (heats to 155°F/68°C), Heat Dry, Delay Start (4 hours)
  • Capacity: 10-12 place settings
  • DishSense® Technology adjusts cycle; adjustable racks with fold-down tines
  • Stainless steel tub; rinse aid dispenser
  • Quiet operation; Annual Energy: ENERGY STAR certified
• Operating Conditions:
  • Water temperature: 120°F min (49°C)
  • Humidity: Non-condensing

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load upper/lower racks and silverware basket properly, avoiding nesting; place sharp items handles up.
2. Add Detergent: Use automatic dispenser; fresh powder, liquid, or gel based on soil level and water hardness (soft: 1 teaspoon; medium: 1-2 teaspoons; hard: 2 teaspoons + 1/2 cup for heavily soiled).
3. Add Rinse Aid: Fill dispenser (light indicates low); adjust for drying performance (setting 1-6).
4. Run Hot Water: At sink until hot (120°F+), then close faucet.
5. Select Cycle: Use control panel; confirm with lights.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Heavy Wash, Normal Wash, 1 Hr. Wash, or Rinse Only.
2. Select Options: High Temp Wash (heats to 155°F/68°C, auto on Heavy), Heat Dry (enhances drying with rinse aid), Delay Start (4 hours).
3. Control Lock: Hold Options for 3 seconds to lock.
4. Start: Close door firmly; press START/CANCEL. Unit fills, washes, rinses, dries.
5. Interrupt Cycle: Open door (pauses); add items within 10 minutes, close to resume.
6. Cancel: Hold START/CANCEL for 3 seconds to drain and reset.
Note: DishSense® adjusts cycle time; normal sounds include splashing and motors. Contents hot after High Temp.

Care and Cleaning

1. Filter: Self-cleaning; clean glass trap monthly: pull up/out, empty debris, rinse, replace.
2. Spray Arms: Check and clear clogs monthly with toothpick.
3. Exterior/Interior: Wipe with mild soap; no abrasives.
4. Monthly Clean: 2 cups white vinegar in bottom rack, run Normal (no detergent).
5. Rinse Aid: Refill as needed; adjust dispenser setting.
Note: Use dishwasher-safe items only; clean overfill protector.

Troubleshooting

• Won't Start: Check power, door latch, cycle selected, no Delay Start.
  
• No Water Fill: Water supply on? Clean inlet screen; pressure 20+ PSI.
  
• Poor Drainage: Hose kinked? Disposer empty? Clean filter.
  
• Soils on Dishes: Pre-rinse heavy soils; use correct cycle/detergent; hot water.
  
• Spotting/Filming: Increase rinse aid; test water hardness; vinegar clean.
  
• Not Drying: Select Heat Dry; unload promptly.
  
• Leaking: Level unit; check door seal; correct detergent amount.
  
• Long Cycles: Normal with options; DishSense® adjusts.
  Note: If issues persist, contact Frigidaire at 1-800-374-4432.

Installation Instructions

Warning: Disconnect power and water before installation. Follow local codes; improper setup may void warranty. Use qualified technician for electrical. Detailed installation not in Use & Care manual; refer to separate Installation Guide.

Remove Old Dishwasher

• Shut off power at breaker and water supply.
  
• Disconnect drain hose, water line, electrical.
  
• Unfasten from cabinet/counter; slide out.
  
• Cap lines to prevent drips.

Installing New Dishwasher

1. Cabinet Prep: 24" W x 24" D opening; utilities access.
   
2. Level Legs: Adjust to fit under counter (33-1/2" min height).
   
3. Door Springs: Adjust for balance.
   
4. Route Hoses/Wires: Through cabinet hole.
   
5. Slide In: Align, push fully; connect drain first.
   
6. Level: Front-to-back and side-to-side.
   
7. Secure: Screws to countertop/cabinet.
   
8. Connect Water/Drain/Electrical: See subsections.
   
9. Test: Check for leaks; run cycle.

Electrical Connections

• 120V/15A dedicated circuit (20A with disposer); no extension cords.
  
• Connect black to hot, white to neutral, green to ground.
  
• Use junction box or cord (3-prong).
  
• Secure with strain relief.

Water Supply

• 3/8" NPT copper tubing; shut-off valve.
  
• Flush line; connect to inlet with ferrule/nut.
  
• 20-120 PSI; 120°F min temp.
  
• Avoid kinks.

Drain Connection

• High loop or air gap (required by code).
  
• Connect to sink/disposer (remove plug).
  
• Secure clamps; max length 10 ft, min height 32".
  
• No sags in hose.