Frigidaire FFTR1835VW Refrigerator Operation Manual

The Frigidaire FFTR1835VW is an 18 cu. ft. garage-ready top-freezer refrigerator with white finish, featuring adjustable interior storage, humidity-controlled crisper drawers, and ENERGY STAR® certification for efficiency. It provides reliable cooling without an ice maker or water dispenser. Ideal for compact kitchens, it's compatible with standard electrical systems. Below are the key specifications and operation instructions.

Key Specifications

• Type: 18 cu. ft. top-freezer refrigerator with white finish
• Compatibility:
  • Residential use; ENERGY STAR® certified
  • Standard 120V, 60Hz household current
  • No water connection required
• Power Source:
  • 120 V, 60 Hz; 15A circuit
  • Grounded outlet required
• Electrical Rating:
  • 15A fuse or circuit breaker
  • 2-wire with ground
• Dimensions: 30" W x 29.875" D x 66.125" H
• Features:
  • Capacities: Total 18 cu. ft., Refrigerator 14.1 cu. ft., Freezer 3.9 cu. ft.
  • Mechanical temperature controls
  • Adjustable glass shelves, full-width crisper drawer with humidity control
  • Full-width freezer shelf, door racks
  • Reversible door, automatic defrost
  • Annual Energy: 404 kWh
• Operating Conditions:
  • Ambient temperature: 55°F - 110°F (13°C - 43°C)
  • Non-condensing humidity

Operation Instructions

Initial Setup

1. Unpack and Remove Materials: Remove all packaging, tape, and protective coverings from shelves and drawers.
2. Install Shelves: Place glass shelves and crisper drawer in desired positions.
3. Plug In: Connect to a grounded outlet; do not use extension cords.
4. Set Temperatures: Refrigerator to mid-setting (37°F), Freezer to mid (0°F); allow 24 hours to stabilize.
5. Load Food: Place items allowing air circulation; do not block vents.
Note: Clean interior with mild soap and water before use.

Temperature Controls

1. Location: Controls are typically inside the refrigerator compartment on the back wall.
2. Refrigerator Control: Settings 1 (warmest) to 9 (coldest); recommended 4-5 for 37°F.
3. Freezer Control: Settings 1 (warmest) to 9 (coldest); recommended 4-5 for 0°F.
4. Adjustments: Turn dial clockwise to increase cold; monitor with thermometer.
5. Power Failure: Food safe up to 24 hours if doors closed.
Note: Overloading or blocking vents affects performance.

Care and Cleaning

1. Interior: Wipe with mild soap and warm water; dry thoroughly.
2. Shelves/Drawers: Remove and wash; glass shelves in dishwasher if labeled.
3. Exterior: Clean with soft cloth and mild cleaner; avoid abrasives.
4. Coils: Vacuum condenser coils every 6 months for efficiency.
5. Defrost Freezer: Automatic; if frost builds, unplug and defrost manually.
Note: Unplug unit before cleaning; replace door gaskets if worn.

Troubleshooting

• Not Cooling: Check power supply, temperature settings, door seals, vents clear; ensure level.
  
• Too Warm: Adjust controls colder; avoid overloading; clean coils.
  
• Noisy: Normal compressor hum; level unit; check for loose parts.
  
• Door Issues: Level refrigerator; check hinges and seals.
  
• Light Not Working: Replace bulb with compatible type (40W max).
  
• Odors: Clean interior; use baking soda box.
  Note: If issues persist, contact Frigidaire at 1-800-374-4432.

Installation Instructions

Warning: Disconnect power before installation. Follow local codes; improper setup may void warranty.

Unpacking and Site Preparation

• Remove from carton; inspect for damage.
  
• Select location: 2" clearance on sides, 1" top/rear; flat, sturdy floor.
  
• Ensure 115V grounded outlet nearby; floor supports 200+ lbs.
  
• Protect flooring during positioning.

Leveling and Door Adjustment

1. Adjust Legs: Turn front leveling legs to raise/lower for stability.
   
2. Check Level: Use level tool side-to-side and front-to-back.
   
3. Door Reversal: If needed, follow instructions for reversible door.
   
4. Align Doors: Ensure they close properly and seal.

Electrical Connections

• 120V/15A dedicated grounded outlet; no extensions or adapters.
  
• Plug power cord directly into wall outlet.
  
• Avoid locations prone to moisture or heat.