Frigidaire FGHC2331PFAA Refrigerator Operation Manual

The Frigidaire FGHC2331PFAA is a 22.2 cu. ft. counter-depth side-by-side refrigerator with stainless steel finish, featuring PureSource® Ultra water filtration, adjustable shelving, and Express-Select® controls. It offers ENERGY STAR® certification and space-efficient organization. Ideal for modern kitchens, it's compatible with standard electrical and water systems. Below are the key specifications and operation instructions.

Key Specifications

• Type: 22.2 cu. ft. counter-depth side-by-side refrigerator with stainless steel finish
• Compatibility:
  • Residential use; ENERGY STAR® certified
  • Standard 120V, 60Hz household current
  • Water pressure: 20-120 PSI for dispenser
  • Hot water not required
• Power Source:
  • 120 V, 60 Hz; 15A minimum circuit
  • Grounded outlet required
• Electrical Rating:
  • 8.5 Amps
  • 2-wire with ground
• Dimensions: 35.625" W x 31.5" D x 69.875" H (with doors closed)
• Features:
  • Capacities: Fresh Food 14.7 cu. ft., Freezer 7.5 cu. ft.
  • Express-Select® Controls with Quick Ice and Quick Freeze
  • SpillSafe® shelves, humidity-controlled crispers
  • Adjustable door bins, LED lighting
  • Ice maker with on/off control, water/ice dispenser
  • PureSource® Ultra Water Filter
  • Frost-free operation, Quiet Pack sound package
  • Annual Energy: 647 kWh
• Operating Conditions:
  • Ambient temperature: 55°F - 110°F (13°C - 43°C)
  • Non-condensing humidity

Operation Instructions

Initial Setup

1. Unpack and Remove Materials: Remove all packaging, tape, and protective film from shelves and drawers.
2. Level the Unit: Adjust front rollers for stability (see installation).
3. Plug In: Connect to grounded outlet; avoid extension cords.
4. Set Temperatures: Initial: Refrigerator 37°F, Freezer 0°F; allow 24 hours for stabilization.
5. Install Filters: Insert water filter if not pre-installed; flush 2-3 gallons of water.
6. Clean Interior: Wipe with mild soap before first use.
Note: Ensure proper airflow; do not block vents.

Temperature Controls

1. Access Controls: Use capacitive touch panel on dispenser.
2. Refrigerator: Adjustable from 33°F to 47°F; recommended 37°F.
3. Freezer: Adjustable from -6°F to 6°F; recommended 0°F.
4. Quick Freeze/Ice: Activates for 12 hours to rapidly cool; auto-off.
5. Energy Saver: Reduces compressor runtime for efficiency.
6. Alerts: Door ajar, power failure, filter change indicators.
Note: Adjust based on usage; overpacking affects cooling.

Ice and Water Dispenser

1. Turn On Ice Maker: Switch to ON position in freezer.
2. Select Type: Press for cubed or crushed ice; water paddle for water.
3. Dispenser Light: Auto-on when dispensing; toggle display on/off.
4. Filter Replacement: Change every 6 months; indicator light alerts.
5. Troubleshoot Low Ice: Check water supply, bin not full, temperature.
Note: Discard first ice; do not use with non-Frigidaire filters.

Care and Cleaning

1. Interior: Wipe with mild soap and water; dry thoroughly.
2. Shelves/Drawers: Remove and wash; SpillSafe® shelves wipe clean.
3. Exterior: Clean with soft cloth and stainless steel cleaner.
4. Coils: Vacuum every 6 months for efficiency.
5. Filters: Replace water filter every 6 months.
Note: Unplug before deep cleaning; avoid abrasive cleaners.

Troubleshooting

• Not Cooling: Check power, temperature settings, door seals, vents unobstructed.
  
• No Ice/Water: Verify water supply on, filter not clogged, ice maker on.
  
• Noisy Operation: Normal fan/compressor sounds; level unit; check for loose parts.
  
• Odors: Clean interior; use baking soda; check air filter.
  
• Door Not Closing: Level unit; adjust hinges if needed.
  
• Light Not Working: Check bulb; replace with compatible LED.
  Note: If issues persist, contact Frigidaire at 1-800-374-4432.

Installation Instructions

Warning: Disconnect power before installation. Follow local codes; improper setup may void warranty.

Unpacking and Site Preparation

• Remove from carton; inspect for damage.
  
• Choose location: 1" clearance on sides/top, 1" rear, near water line.
  
• Ensure floor can support 300 lbs.
  
• Protect flooring during move.

Leveling and Door Adjustment

1. Adjust Rollers: Turn front leveling screws to raise/lower.
   
2. Check Level: Use bubble level side-to-side and front-to-back.
   
3. Door Alignment: Adjust hinges if doors misaligned.
   
4. Secure: Ensure stable; doors close properly.

Electrical Connections

• 120V/15A dedicated circuit; no extension cords.
  
• Plug directly into wall.
  
• Avoid power strips.

Water Supply Connection

• 1/4" copper tubing; shut-off valve within 6 ft.
  
• Connect to inlet at rear; use compression nut.
  
• 20-120 PSI; flush line before connecting.
  
• Coil excess tubing behind unit.