Frigidaire FGHD2433KF1 Dishwasher Operation Manual

The Frigidaire FGHD2433KF1 is a 24-inch built-in dishwasher from the Gallery series with stainless steel finish, featuring OrbitClean® wash system for superior cleaning coverage, DishSense® Technology to adjust cycles based on soil levels, and ENERGY STAR® certification for efficiency. It offers 14 place settings capacity and quiet operation around 50 dBA. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: 24-inch built-in dishwasher with OrbitClean® wash system and DishSense® Technology
Compatibility:
- Residential use; ENERGY STAR® certified
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit (dedicated)
- Grounded outlet required
Electrical Rating:
- 15A fuse or circuit breaker
- 2-wire with ground
Dimensions: 24" W x 25" D x 33-1/2" - 34-1/2" H (adjustable)
Features:
- Wash cycles: Heavy, Normal, Quick Wash, Upper Rack, Rinse Only
- Options: Heat Dry, Hi-Temp Wash, Sanitize (NSF certified), Delay Start
- Capacity: 14 place settings
- Adjustable racks; dual spray arms
- Stainless steel tub; rinse aid dispenser
- Quiet: 50 dBA; Annual Energy: 270 kWh
Operating Conditions:
- Water temperature: 120°F min (49°C)
- Humidity: Non-condensing
Wash Cycle Details:
- Normal: ~2 hrs, ~5 gal
- Heavy: ~2.5 hrs, ~7 gal
- Quick Wash: ~1 hr, ~4 gal
- Rinse Only: ~30 min, ~2 gal

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load upper/lower racks and silverware basket properly, avoiding nesting; place sharp items handles up.
2. Add Detergent: Use automatic dispenser; fresh powder, liquid, or gel based on soil level and water hardness.
3. Add Rinse Aid: Fill dispenser (light indicates low); adjust for drying performance.
4. Run Hot Water: At sink until hot (120°F+), then close faucet.
5. Select Cycle: Use control panel; confirm with lights.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Heavy, Normal, Quick Wash, Upper Rack, or Rinse Only.
2. Select Options: Heat Dry, Hi-Temp Wash, Sanitize, Delay Start.
3. Control Lock: Hold Start for 3 seconds to lock.
4. Start: Close door; press Start. Fills, washes, rinses, dries.
5. Interrupt: Open door to pause; close to resume.
6. Cancel: Hold Start for 3 seconds to drain and reset.
Note: Contents hot after Sanitize; do not tamper with controls.

Care and Cleaning

1. Filter: Clean monthly; remove and rinse under water.
2. Spray Arms: Check and clear clogs monthly.
3. Exterior/Interior: Wipe with mild soap; no abrasives.
4. Monthly Clean: Place 2 cups vinegar in bottom rack, run Normal cycle (no detergent).
5. Rinse Aid: Refill as needed; adjust setting.
Note: Use dishwasher-safe items only.

Troubleshooting

Won't Start: Check power, door latch, selected cycle; no lock or delay.
No Water: Verify supply on, clean inlet screen, pressure adequate.
Poor Drain: Check hose for kinks, empty disposer, clean filter.
Soils Remain: Pre-rinse heavy soils; right cycle and detergent; ensure hot water.
Spotting: Use more rinse aid; check water hardness.
Poor Drying: Select Heat Dry; unload hot dishes promptly.
Leaking: Level unit; inspect door seal; use correct detergent.
Note: Contact 1-800-944-9044 for assistance.

Installation Instructions

Warning: Disconnect power and water before starting. Follow local codes; improper installation may void warranty.

Remove Old Dishwasher

Turn off power at breaker and water supply.
Disconnect drain, water, electrical connections.
Remove from cabinet; cap lines.

Installing New Dishwasher

Prepare Cabinet: Ensure 24" W x 24" D opening; access to utilities.
Adjust Legs: For under-counter fit (min 33-1/2" height).
Door Springs: Adjust for proper balance.
Route Lines: Through access hole.
Position: Slide in, connect drain first.
Level: Adjust front-to-back and side-to-side.
Secure: Fasten to countertop/cabinet.
Connect: Water, drain, electrical (see below).
Test: Run cycle to check leaks.

Electrical Connections

120V/15A dedicated circuit; no extensions.
Connect hot (black), neutral (white), ground (green).
Use junction box or 3-prong cord with strain relief.

Water Supply

3/8" NPT tubing; install shut-off valve.
Flush line before connecting.
20-120 PSI; min 120°F water.
Avoid kinks in line.

Drain Connection

High loop or air gap required.
Connect to sink or disposer (remove knockout plug).
Secure with clamps; max 10 ft length, min 32" height.
No sags.