The Frigidaire FGHD2465NF1A is a 24-inch built-in dishwasher from the Gallery series with stainless steel finish, featuring OrbitClean® wash system and DishSense® Technology. This service manual provides technical data, diagnostics, wiring diagrams, component testing, and parts information for qualified technicians. Always disconnect power before servicing. Refer to the service data sheet for detailed procedures. Below are the key sections.
Code | Meaning | Troubleshooting |
---|---|---|
PF | Power failure | Open/close door to clear; check power supply. |
HO | Heat delay/low water temp | Ensure hot water supply 120°F+. |
LO | Low rinse aid | Refill dispenser. |
i10 | Low water level | Check supply line, leaks, kinks. |
i20/i40/iFo | Drain line restricted | Clear blockages in hose/filter. |
i30 | Leak in bottom pan | Inspect for pooling water, hose connections. |
i50 | Drain/wash motor failure | Check for blockages; test motor. |
iCo | Electronic control failure | Hard reset (unplug 5 min); call service. |
ER | Membrane switch failure | Massage buttons; replace keypad. |
CE | Configuration error | Check communication; professional repair. |
CL | Door open/switch open | Close door; check switch. |
dP | Drain pump activated (test) | Diagnostic mode; clear if needed. |
FL | Water valve open (test) | Diagnostic mode; close valve. |
Hs | Hall sensor error | Replace sensor. |
rA | Rinse aid reed switch failure | Replace dispenser. |
Rt | Relay/triac test | Test mode; reset. |
Tu | Turbidity sensor failure | Replace sensor. |
i60 | Water heating system problem | Test heater; professional. |
UL | UL test activated | Test mode; reset. |
Refer to Wiring Diagram in tech sheet. Key connections: