Frigidaire FGID2466QF Dishwasher Operation Manual

The Frigidaire FGID2466QF is a 24-inch built-in dishwasher from the Gallery series with stainless steel finish, featuring DishSense® Technology for automatic cycle adjustment and OrbitClean® spray arm for better coverage. It offers up to 14 place settings capacity, ENERGY STAR® certification, and quiet operation. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: 24-inch built-in dishwasher with DishSense® Technology and OrbitClean® spray arm
Compatibility:
- Residential use; ENERGY STAR® certified
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit (dedicated)
- Grounded outlet required
Electrical Rating:
- 15A fuse or circuit breaker
- 2-wire with ground
Dimensions: 24" W x 25" D x 33-1/2" - 34-1/2" H (adjustable)
Features:
- Wash cycles: Power Plus, Normal Wash Top Rack, Energy Saver, Favorite Cycle
- Options: Heat Dry, Air Dry, Hi-Temp Wash, Sanitize (NSF certified), Delay Start
- Capacity: 14 place settings
- Adjustable racks with fold-down tines; dual spray arms
- Stainless steel tub; rinse aid dispenser with adjustment
- Quiet operation; Annual Energy: ENERGY STAR qualified
Operating Conditions:
- Water temperature: 120°F min (49°C)
- Humidity: Non-condensing
Wash Cycle Details:
- Power Plus: Heavy-duty, ~2.5 hrs, ~7 gal
- Normal Wash Top Rack: Upper only, ~1 hr, ~4 gal
- Energy Saver: Efficient, ~1 hr, ~4.5 gal
- Favorite: Programmable, varies

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load upper/lower racks and silverware basket properly, avoiding nesting; place sharp items handles up.
2. Add Detergent: Use automatic dispenser; fresh powder, liquid, or gel based on soil level and water hardness.
3. Add Rinse Aid: Fill dispenser (indicator shows low); adjust for drying and spotting.
4. Run Hot Water: At sink until hot (120°F+), then close.
5. Select Cycle: Use control panel; confirm with lights.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Power Plus, Normal Wash Top Rack, Energy Saver, or Favorite.
2. Select Options: Heat Dry (for better drying), Air Dry, Hi-Temp Wash, Sanitize, Delay Start.
3. Control Lock: Hold Start for 3 seconds to lock.
4. Start: Close door; press Start. Fills, washes, rinses, dries; DishSense® adjusts time.
5. Interrupt: Open door to pause; close to resume.
6. Cancel: Hold Start for 3 seconds to drain and reset.
Note: Status lights off when door closed; vapor at vent normal. Contents hot after Sanitize.

Care and Cleaning

1. Filter: Self-cleaning; clean glass trap monthly: remove, rinse under water.
2. Spray Arms: Check and clear clogs monthly.
3. Exterior/Interior: Wipe with mild soap; no abrasives; allow heating element to cool.
4. Monthly Clean: 2 cups white vinegar in bottom rack, run Normal (no detergent).
5. Rinse Aid: Refill as needed; adjust setting.
Note: Clean drain air gap if installed; winterize in cold areas.

Troubleshooting

Won't Start: Check power, door latch, cycle selected; reset breaker.
No Lights: Normal with door closed; open to view.
Poor Drainage: Clean filter, air gap; check hose kinks.
Soils Remain: Use hot water; right cycle/detergent; check loading.
Spotting/Etching: Adjust detergent for water hardness; use rinse aid; vinegar clean.
Poor Drying: Select Heat Dry; use rinse aid; tilt cups.
Leaking: Level unit; check door seal.
Error "Uo": Contact support at 1-800-944-9044.
Note: For odors or overflow, clean immediately.

Installation Instructions

Warning: Disconnect power and water before installation. Follow local codes; improper setup may void warranty. Use qualified technician.

Remove Old Dishwasher

Shut off power at breaker and water supply.
Disconnect drain hose, water line, electrical.
Unfasten from cabinet/counter; slide out.
Cap lines to prevent drips.

Installing New Dishwasher

Cabinet Prep: 24" W x 24" D opening; utilities access.
Level Legs: Adjust to fit under counter (33-1/2" min height).
Door Springs: Adjust for balance.
Route Hoses/Wires: Through cabinet hole.
Slide In: Align, push fully; connect drain first.
Level: Front-to-back and side-to-side.
Secure: Screws to countertop/cabinet.
Connect Water/Drain/Electrical: See subsections.
Test: Check for leaks; run cycle.

Electrical Connections

120V/15A dedicated circuit; no extension cords.
Connect black to hot, white to neutral, green to ground.
Use junction box or cord (3-prong).
Secure with strain relief.

Water Supply

3/8" NPT copper tubing; shut-off valve.
Flush line; connect to inlet with ferrule/nut.
20-120 PSI; 120°F min temp.
Avoid kinks.

Drain Connection

High loop or air gap (required by code; clean periodically).
Connect to sink/disposer (remove plug).
Secure clamps; max length 10 ft, min height 32".
No sags in hose.