Frigidaire FGID2476SF0A Dishwasher Operation Manual

The Frigidaire FGID2476SF0A is a 24-inch built-in dishwasher from the Gallery series with stainless steel finish, featuring EvenDry™ drying system for thorough drying and advanced wash capabilities. It offers 14 place settings capacity, ENERGY STAR® certification, and quiet operation. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Operation Instructions

Initial Setup

1. Load Dishes: Scrape food soils; load racks properly, avoiding nesting. Place sharp items with handles up.
2. Add Detergent: Use dispenser; fresh powder, liquid, or gel based on soil level.
3. Add Rinse Aid: Fill dispenser (light indicates low); adjust for drying.
4. Run Hot Water: At sink until hot, then close faucet.
5. Select Cycle: Use control panel; confirm with lights.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Normal, Heavy, Quick Wash, Upper Rack Only, or Rinse Only.
2. Select Options: Heat Dry (for better drying), Hi-Temp Wash, Sanitize, Delay Start.
3. Control Lock: Hold Start for 3 seconds to lock.
4. Start: Close door; press Start. Fills, washes, rinses, dries.
5. Interrupt: Open door to pause; close to resume.
6. Cancel: Hold Start for 3 seconds to drain and reset.
Note: Do not tamper with controls; contents hot after Sanitize.

Care and Cleaning

1. Filter: Clean monthly; remove and rinse under water.
2. Spray Arms: Check and clear clogs monthly.
3. Exterior/Interior: Wipe with mild soap; no abrasives.
4. Monthly Clean: Place 2 cups vinegar in bottom rack, run Normal cycle (no detergent).
5. Rinse Aid: Refill as needed; adjust setting.
Note: Use dishwasher-safe items only.

Troubleshooting

Installation Instructions

Warning: Disconnect power and water before starting. Follow local codes; improper installation may void warranty.

Remove Old Dishwasher

Installing New Dishwasher

  1. Prepare Cabinet: Ensure 24" W x 24" D opening; access to utilities.
  2. Adjust Legs: For under-counter fit (min 33-1/2" height).
  3. Door Springs: Adjust for proper balance.
  4. Route Lines: Through access hole.
  5. Position: Slide in, connect drain first.
  6. Level: Adjust front-to-back and side-to-side.
  7. Secure: Fasten to countertop/cabinet.
  8. Connect: Water, drain, electrical (see below).
  9. Test: Run cycle to check leaks.

Electrical Connections

Water Supply

Drain Connection

Frigidaire Dishwasher Manual© - All Rights Reserved 2025