Frigidaire FGID2476SF7A Dishwasher Operation Manual

The Frigidaire FGID2476SF7A is a 24-inch built-in dishwasher from the Gallery series with stainless steel finish, featuring EvenDry™ drying system and advanced wash capabilities. It offers 14 place settings capacity, ENERGY STAR® certification, and quiet operation. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: 24-inch built-in dishwasher with EvenDry™ drying system
Compatibility:
- Residential use; ENERGY STAR® certified
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit (20A if with disposer)
- Grounded outlet required
Electrical Rating:
- 15A fuse or circuit breaker
- 2-wire with ground
Dimensions: 24" W x 25" D x 33-1/2" - 34-1/2" H (adjustable)
Features:
- Wash cycles: Heavy, Normal, 30 Min Wash, Energy Saver, Rinse Only, China Crystal
- Options: Wash Pressure (Surge/Spray/Scour), Hi-Temp Wash, Sanitize (NSF certified), Heat Dry/Air Dry, Delay Start (1-24 hours), My Favorite
- Capacity: 14 place settings
- Adjustable upper rack, fold-down tines, Soft Grip Rack, status indicators
- Stainless steel tub; rinse aid dispenser with adjustment
- Quiet operation; Annual Energy: 270 kWh
Operating Conditions:
- Water temperature: 120°F min (49°C)
- Humidity: Non-condensing
Wash Cycle Details:
- Heavy: ~2.25-3.25 hrs, 7-7.9 gal
- Normal: Varies, ~2.9-7.3 gal
- 30 Min Wash: ~0.5 hr, 4.5 gal
- Rinse Only: ~0.25 hr, 2 gal

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load upper/lower racks and silverware basket properly, avoiding nesting; place sharp items handles up.
2. Add Detergent: Use automatic dispenser; fresh powder, tablet, or gel, amount per soil level and water hardness.
3. Add Rinse Aid: Fill dispenser (indicator shows level); adjust for spotting (L0-L6).
4. Run Hot Water: At sink until hot (120°F+), then close.
5. Select Cycle: Use controls; lights confirm.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Heavy, Normal, 30 Min Wash, Energy Saver, Rinse Only, or China Crystal.
2. Select Options: Wash Pressure, Hi-Temp Wash, Sanitize (NSF certified), Heat Dry/Air Dry, Delay Start, My Favorite.
3. Control Lock: Hold Delay Start until "loc" displays to lock controls.
4. Start: Close door firmly; press Start. Unit fills, washes, rinses, dries.
5. Interrupt Cycle: Open door (pauses); add items, close to resume after pressing Start.
6. Cancel: Press Start for 3 seconds to drain and reset.
Note: DishSense™ adjusts cycle time; normal sounds include water splashing and motors. Contents hot after Sanitize.

Care and Cleaning

1. Filter: Clean regularly; remove coarse and fine filters, rinse under water.
2. Spray Arms: Check and clear clogs as needed.
3. Exterior/Interior: Wipe with soft cloth and mild soap; avoid abrasives.
4. Monthly Clean: 2 cups white vinegar in bottom rack, run Normal (no detergent).
5. Rinse Aid: Refill as needed; adjust dispenser setting L0-L6.
Note: Use only dishwasher-safe items; clean air gap if installed; winterize in cold areas.

Troubleshooting

Won't Start: Check power, door latch, cycle selected, no Delay Start or lock.
No Water Fill: Water supply on? Pressure 20+ PSI; run hot water first.
Poor Drainage: Hose kinked? Disposer empty and plug removed? Clean filters.
Soils on Dishes: Pre-rinse heavy soils; use correct cycle/detergent/temp; check loading.
Spotting/Filming: Hard water? Increase rinse aid; test hardness; use vinegar clean.
Not Drying: Select Heat Dry; use rinse aid; unload promptly.
Leaking: Level unit; check door seal; correct detergent amount.
Long Cycles: Normal with options or heating; DishSense® adjusts.
Note: Check error codes in status window; if issues persist, contact Frigidaire at 1-800-944-9044.

Installation Instructions

Warning: Disconnect power and water before installation. Follow local codes; improper setup may void warranty. Use qualified technician for electrical.

Remove Old Dishwasher

Shut off power at breaker and water supply.
Disconnect drain hose, water line, electrical.
Unfasten from cabinet/counter; slide out.
Cap lines to prevent drips.

Installing New Dishwasher

Cabinet Prep: 24" W x 24" D opening; utilities access.
Level Legs: Adjust to fit under counter (33-1/2" min height).
Door Springs: Adjust for balance.
Route Hoses/Wires: Through cabinet hole.
Slide In: Align, push fully; connect drain first.
Level: Front-to-back and side-to-side.
Secure: Screws to countertop/cabinet.
Connect Water/Drain/Electrical: See subsections.
Test: Check for leaks; run cycle.

Electrical Connections

120V/15A dedicated circuit (20A with disposer); no extension cords.
Connect black to hot, white to neutral, green to ground.
Use junction box or cord (3-prong).
Secure with strain relief.

Water Supply

3/8" NPT copper tubing; shut-off valve.
Flush line; connect to inlet with ferrule/nut.
20-120 PSI; 120°F min temp.
Avoid kinks.

Drain Connection

High loop or air gap (required by code).
Connect to sink/disposer (remove plug).
Secure clamps; max length 10 ft, min height 32".
No sags in hose.