Frigidaire FPHD2491KF0 Dishwasher Operation Manual

The Frigidaire FPHD2491KF0 is a 24-inch built-in dishwasher featuring Smart Soil Sensor for automatic cycle adjustment, multiple wash cycles, and options like Hi-Temp Wash and Sanitize for efficient cleaning. It accommodates up to 14 place settings and includes a continuous filtered wash system. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: 24-inch built-in dishwasher with Smart Soil Sensor and continuous filtered wash system
Compatibility:
- Residential use; NSF certified for sanitization
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit
- Individual grounded branch circuit
Electrical Rating:
- 15A fuse or circuit breaker
- 2-wire with ground
Dimensions: Standard 24" width; height adjustable to 33-1/2" - 34-1/2" H
Features:
- Wash cycles: Power Plus, Light Wash, Normal Wash
- Options: Hi-Temp Wash (140°F/60°C), Sanitize, Air Dry/Heat Dry
- Capacity: Up to 14 place settings
- Self-cleaning filter, rinse aid dispenser, adjustable racks, silverware basket
- Quiet operation with energy-efficient motors
Operating Conditions:
- Water temperature: 120°F minimum (up to 140°F with Hi-Temp Wash)
- Humidity: Non-condensing
Wash Cycle Details:
- Power Plus: Variable time based on soil, with additional fills if needed
- Light Wash: Variable, for lightly soiled dishes
- Normal Wash: Variable, for normally soiled dishes

Operation Instructions

Initial Setup

1. Register Product: Online at www.frigidaire.com.
2. Check Water Temperature: Run hot faucet; ensure ≥120°F.
3. Add Rinse Aid: Fill dispenser; adjust 1-6 for spotting prevention.
4. Load Dishes: Scrape food; load per patterns, soiled sides toward spray arms.
5. Add Detergent: Use fresh automatic detergent; amount per water hardness.
6. First Use: Run empty Normal cycle after flushing hot water.
Warning: Do not wash non-dishwasher safe items; may cause fire hazard.

Operating the Dishwasher

1. Load Properly: Scrape large food; no nesting; secure items.
2. Add Detergent: Main cup for wash, pre-wash for heavy soils.
3. Select Cycle: Power Plus for heavy, Normal for daily, Light for light; Smart Soil Sensor adjusts.
4. Select Options: Hi-Temp Wash (140°F), Sanitize (NSF certified), Heat Dry/Air Dry.
5. Start: Close door to latch; press Start; unit fills and washes.
6. Interrupt: Open door to pause; close to resume.
7. Cancel: Press Start to drain/reset.
Note: Cycle times vary with soil and water temp; normal sounds include splashing and draining.

Care and Cleaning

1. Exterior: Mild nonabrasive detergent; rinse and dry.
2. Interior: Mild detergent; for spots, run with 2 cups vinegar.
3. Fine Filter: Remove, rinse under water monthly; replace.
4. Spray Arms: Clean nozzles if clogged.
Warning: Allow heating element to cool before cleaning.

Troubleshooting

Dishes Not Dry: Select Heat Dry; fill rinse aid.
Leaking: Check water in bottom; use fresh detergent.
Does Not Drain: Empty disposer; check hose kinks.
Spots/Film: Test hardness; adjust rinse aid/detergent.
Error Codes: "CE" for water fill issues; contact 1-800-944-9044.
Note: Review list before service.

Installation Instructions

Warning: Disconnect power and water; follow local codes.

Remove Old Dishwasher

Shut off power at breaker and water supply.
Disconnect drain hose, water line, electrical.
Unfasten from cabinet/counter; slide out.
Cap lines to prevent drips.

Installing New Dishwasher

Prepare Cabinet: Ensure 24" W x 24" D opening; access to utilities.
Level Legs: Adjust for fit under counter.
Route Hoses/Wires: Through cabinet hole.
Slide In: Align, push fully; connect drain first.
Level: Front-to-back and side-to-side.
Secure: Screws to countertop/cabinet.
Connect Water/Drain/Electrical: See subsections.
Test: Check for leaks; run cycle.

Electrical Connections

120V/15A dedicated circuit; no extension cords.
Connect black to hot, white to neutral, green to ground.
Use junction box or cord (3-prong).
Secure with strain relief.

Water Supply

Hot water line; 20-120 PSI.
Flush line; connect to inlet with ferrule/nut.
120°F min temp.
Avoid kinks.

Drain Connection

High loop or air gap (required by code).
Connect to sink/disposer (remove plug).
Secure clamps; max length 10 ft, min height 32".
No sags in hose.