Frigidaire Gallery FGHF2366PF Refrigerator Operation Manual

The Frigidaire Gallery FGHF2366PF is a 21.9 Cu. Ft. counter-depth French door refrigerator with bottom freezer drawer, featuring automatic ice maker, water dispenser, and PureSource Ultra water filtration. It offers adjustable shelving, humidity-controlled crispers, and energy-efficient cooling for optimal food preservation. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Refrigerator 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Refrigerator 3.2. Installing New Refrigerator 3.3. Electrical Connections 3.4. Water Supply and Ice Maker Connection

Key Specifications

Type: French door refrigerator with bottom freezer drawer, automatic ice maker, water dispenser
Compatibility:
- Household water systems; 30-100 psi pressure; cold water line with ¼ inch OD copper/stainless steel tubing
- Operating temperature: 55°F to 110°F (13°C to 43°C)
- NSF/ANSI certified water filter (Standards 42 and 53)
Power Source:
- 115 Volt, 60 Hz, 15 Amp dedicated grounded outlet
- Three-prong grounding plug; avoid GFI circuits or extensions
Electrical Rating:
- 15 Amp circuit; voltage variation over 10% may damage compressor
Dimensions: Allow ⅜ inch clearance on sides/top, 1 inch on back; tilt ¼ inch front-to-back for door seal
Features:
- SpillSafe glass shelves, humidity-controlled crispers, adjustable door bins, Store-More drawer
- Ice production: 2.5-3 lbs/24 hrs (fresh food), 2-2.5 lbs/24 hrs (freezer); bin capacities vary by depth
- Water filter (200 gallons), air filter (replace every 6 months), Quick Freeze function
- Controls: Temperature settings (33°F-47°F fridge, -6°F-6°F freezer), alarms, Sabbath mode, control lock
- Dispenser: Water, cubed/crushed ice; LED lights
Operating Conditions:
- Refrigerator: 33°F to 47°F (1°C to 8°C); Freezer: -6°F to 6°F (-21°C to -15°C)

Operation Instructions

Initial Setup

1. Unpack: Remove shipping materials, staples, and packaging; destroy carton and plastics to prevent child suffocation.
2. Install Handles: Position over shoulder bolts and tighten set screws.
3. Plug In: Connect to dedicated 115V outlet; allow 20 minutes for initial cooling (display shows "HI").
4. Set Temperatures: Refrigerator to 37°F, freezer to 0°F.
5. Connect Water (if applicable): Prime system by dispensing 1½ minutes water, then 4 minutes to flush.
6. Check Seals: Ensure doors seal completely; level unit.
Warning: Do not store flammable liquids near unit; unplug before service.

Operating the Refrigerator

1. Controls: Use ∧/∨ to navigate, +/− to adjust temperatures; confirm with set.
2. Temperature Adjustment: Fridge 33°F-47°F, freezer -6°F-6°F; allow 24 hours for stabilization.
3. Ice Maker: Toggle on/off; discard first ice after priming.
4. Dispenser: Select water/cube/crush; shutoff after 3 minutes.
5. Alarms: Power failure, high temp, door ajar; reset via set.
6. Other Functions: Quick Freeze (12 hours), Sabbath mode (hold ∨ and + for 5 seconds), control lock (hold 3 seconds).
Note: Normal sounds include motor hum, ice dropping, and fan operation.

Care and Cleaning

1. Unplug Unit: Before cleaning.
2. Interior: Use soap/water or baking soda solution; wipe spills immediately.
3. Shelves/Drawers: Remove and clean with mild detergent; avoid dishwasher.
4. Exterior: Soap/water or stainless cleaner; clean with grain.
5. Ice Bin: Turn off maker, empty, clean with mild detergent.
6. Filters: Replace water every 6 months/200 gallons, air every 6 months; flush after replacement.
7. Lights: Replace LED or 40W incandescent bulbs (unplug first).
Warning: Handle glass shelves carefully to avoid breakage; damp objects stick to cold surfaces.

Troubleshooting

No Ice: Check ice maker on, water supply/filter/pressure; replace filter if clogged.
Dispenser Issues: Unlock controls, check bin/doors; reset motor.
Doors Not Closing: Level unit, clean tracks/gaskets.
Running Too Much: Hot weather, frequent openings, dirty condenser; clean condenser.
Alarms Flashing: Reset or call service for codes.
Moisture/Frost: Humid weather, open doors; dry produce before storing.
Odd Water Taste: Dispense 10-12 glasses; replace filter.
Note: Frequent compressor cycling is normal; consult service for persistent issues.

Installation Instructions

Warning: Professional installation recommended; follow local codes. Disconnect power before starting.

Remove Old Refrigerator

Remove doors and leave shelves in place to prevent child entrapment.
Have refrigerant removed by qualified technician.
Dispose properly per ENERGY STAR guidelines.

Installing New Refrigerator

Choose Location: Near grounded outlet, level floor, adequate clearances.
Level Unit: Adjust front rollers for ¼ inch tilt front-to-back; side-to-side level.
Install Handles: Tighten set screws over shoulder bolts.
Adjust Doors: Set door stop, lower hinge, flipper mullion for proper seal.
Secure Anti-Tip: Install bracket to floor.
Connect Water: See subsection.
Plug In and Test: Set temperatures, check seals and operation.

Electrical Connections

Plug into dedicated 115V/15A grounded three-prong outlet.
No extension cords, adapters, or GFI circuits.
Grip plug to unplug; consult electrician if needed.
Warning: Grounding reduces shock risk; do not cut/remove prong.

Water Supply and Ice Maker Connection

Use ¼ inch OD copper/stainless tubing; connect to household cold water line with shutoff valve.
Pressure 30-100 psi; flush line before connecting.
Route tubing carefully to avoid kinks; connect to refrigerator inlet.
Turn on supply, check for leaks; prime dispenser.
Caution: Do not use plastic tubing; maintain water softener.