Frigidaire LFID2422RF1A Dishwasher Operation Manual

The Frigidaire LFID2422RF1A is a 24-inch built-in dishwasher with fingerprint-resistant EasyCare stainless steel finish, featuring a wash arm and dual filtration system for thorough cleaning, 4 cycles, and ENERGY STAR® certification. It offers 14 place settings capacity and quiet 55 dBA operation. Ideal for modern kitchens, it's compatible with standard plumbing and electrical systems. Below are the key specifications and operation instructions.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Operating the Dishwasher 2.3. Care and Cleaning 2.4. Troubleshooting 3. Installation Instructions 3.1. Remove Old Dishwasher 3.2. Installing New Dishwasher 3.3. Electrical Connections 3.4. Water Supply 3.5. Drain Connection

Key Specifications

Type: 24-inch built-in dishwasher with integrated controls and dual filtration system
Compatibility:
- Residential use; ENERGY STAR® certified
- Standard 120V, 60Hz household current
- Water pressure: 20-120 PSI
- Hot water supply at least 120°F (49°C)
- Compatible with food waste disposers (if empty)
Power Source:
- 120 V, 60 Hz; 15A circuit (dedicated)
- Grounded outlet required
Electrical Rating:
- 15A fuse or circuit breaker
- 2-wire with ground
Dimensions: 24" W x 25" D x 33-1/2" - 34-1/2" H (adjustable)
Features:
- Wash cycles: Heavy, Normal, Upper Rack, Rinse Only
- Options: Heat Dry, Hi-Temp Wash, Sanitize (NSF certified), Delay Start
- Capacity: 14 place settings
- Dual spray arms; hard food disposer; quiet operation at 55 dBA
- Stainless steel tub; rinse aid dispenser
- Annual Energy: ENERGY STAR qualified
Operating Conditions:
- Water temperature: 120°F-140°F (49°C-60°C)
- Humidity: Non-condensing
Wash Cycle Details:
- Normal: ~2 hrs, ~5 gal
- Heavy: ~2.5 hrs, ~7 gal
- Upper Rack: ~1 hr, ~4 gal
- Rinse Only: ~30 min, ~2 gal

Operation Instructions

Initial Setup

1. Load Dishes: Scrape large food particles; load upper/lower racks properly, avoiding nesting.
2. Add Detergent: Use automatic dispenser; fresh powder or gel, amount per soil level.
3. Add Rinse Aid: Fill dispenser (indicator light when low); adjust for spotting.
4. Run Hot Water: At sink until hot, then close.
5. Select Cycle: Use controls; lights confirm.
6. First Use: Run empty Normal cycle with detergent.

Operating the Dishwasher

1. Select Cycle: Press for Heavy, Normal, Upper Rack, or Rinse Only.
2. Select Options: Heat Dry, Hi-Temp Wash, Sanitize, Delay Start.
3. Control Lock: Hold Start for 3 seconds to lock controls.
4. Start: Close door firmly; press Start. Unit fills, washes, rinses, dries.
5. Interrupt Cycle: Open door (pauses); add items, close to resume.
6. Cancel: Hold Start for 3 seconds to drain and reset.
Note: Normal sounds include sprays and drains.

Care and Cleaning

1. Filter: Clean monthly; remove and rinse under water.
2. Spray Arms: Clear clogs with toothpick; check monthly.
3. Exterior/Interior: Wipe with soft cloth and mild soap; avoid abrasives.
4. Monthly Clean: 2 cups white vinegar in bottom rack, run Normal (no detergent).
5. Rinse Aid: Refill as needed; adjust dispenser setting.
Note: Use only dishwasher-safe items.

Troubleshooting

Won't Start: Check power, door latch, cycle selected, no Delay Start.
No Water Fill: Water supply on? Clean inlet screen; pressure 20+ PSI.
Poor Drainage: Hose kinked? Disposer empty? Clean filter.
Soils on Dishes: Pre-rinse heavy soils; use correct cycle/detergent; hot water.
Spotting/Filming: Increase rinse aid; test hardness.
Not Drying: Select Heat Dry; unload promptly.
Leaking: Level unit; check door seal.
Note: If issues persist, contact Frigidaire at 1-800-374-4432.

Installation Instructions

Warning: Disconnect power and water before installation. Follow local codes; improper setup may void warranty.

Remove Old Dishwasher

Shut off power at breaker and water supply.
Disconnect drain hose, water line, electrical.
Unfasten from cabinet/counter; slide out.
Cap lines to prevent drips.

Installing New Dishwasher

Cabinet Prep: 24" W x 24" D opening; utilities access.
Level Legs: Adjust to fit under counter.
Door Springs: Adjust for balance.
Route Hoses/Wires: Through cabinet hole.
Slide In: Align, push fully; connect drain first.
Level: Front-to-back and side-to-side.
Secure: Screws to countertop/cabinet.
Connect Water/Drain/Electrical: See subsections.
Test: Check for leaks; run cycle.

Electrical Connections

120V/15A dedicated circuit; no extension cords.
Connect black to hot, white to neutral, green to ground.
Use junction box or cord (3-prong).
Secure with strain relief.

Water Supply

3/8" NPT copper tubing; shut-off valve.
Flush line; connect to inlet with ferrule/nut.
20-120 PSI; 120°F min temp.
Avoid kinks.

Drain Connection

High loop or air gap (required by code).
Connect to sink/disposer (remove plug).
Secure clamps; max length 10 ft, min height 32".
No sags in hose.