Frigidaire LFSS2612TF4 Refrigerator Operation Manual

The Frigidaire LFSS2612TF4 is a 25.5 cu. ft. side-by-side refrigerator with stainless steel finish, featuring PureSource® Ultra II water filtration, Express-Select® controls, Quick Ice and Quick Freeze options, and ENERGY STAR® certification for efficiency. It offers SpillSafe® shelves, adjustable storage, and a through-the-door ice and water dispenser. Ideal for modern kitchens, it's compatible with standard electrical and water systems. Below are the key specifications and operation instructions.

Key Specifications

• Type: 25.5 cu. ft. side-by-side refrigerator with stainless steel finish
• Compatibility:
  • Residential use; ENERGY STAR® certified
  • Standard 120V, 60Hz household current
  • Water pressure: 20-120 PSI for dispenser
  • Hot water not required
• Power Source:
  • 120 V, 60 Hz; 15A minimum circuit
  • Grounded outlet required
• Electrical Rating:
  • 8.5 Amps
  • 2-wire with ground
• Dimensions: 35.75" W x 31.75" D x 69.75" H (with doors closed)
• Features:
  • Capacities: Fresh Food 15.7 cu. ft., Freezer 9.8 cu. ft.
  • Express-Select® Controls with Quick Ice and Quick Freeze
  • SpillSafe® shelves, humidity-controlled crispers
  • Adjustable door bins, LED lighting
  • Ice maker with on/off control, external water/ice dispenser
  • PureSource® Ultra II Water Filter
  • Frost-free operation, Quiet Sound Technology
  • Annual Energy: 647 kWh
• Operating Conditions:
  • Ambient temperature: 55°F - 110°F (13°C - 43°C)
  • Non-condensing humidity

Operation Instructions

Initial Setup

1. Unpack and Remove Materials: Remove all packaging, tape, and protective film from shelves and drawers.
2. Level the Unit: Adjust front rollers for stability (see installation).
3. Plug In: Connect to grounded outlet; avoid extension cords.
4. Set Temperatures: Initial: Refrigerator 37°F, Freezer 0°F; allow 24 hours for stabilization.
5. Install Filter: Insert water filter; flush 2-3 gallons of water to clear air.
6. Clean Interior: Wipe with mild soap before first use.
Note: Ensure proper airflow; do not block vents.

Temperature Controls

1. Access Controls: Use digital panel on dispenser.
2. Refrigerator: Adjustable from 33°F to 47°F; recommended 37°F.
3. Freezer: Adjustable from -6°F to 6°F; recommended 0°F.
4. Quick Ice/Freeze: Activates for 12 hours to rapidly cool; auto-off.
5. Control Lock: Hold for 3 seconds to lock/unlock.
6. Alerts: Door ajar, high temp, power failure, filter change.
Note: Adjust based on usage; overpacking affects cooling.

Ice and Water Dispenser

1. Turn On Ice Maker: Switch to ON in freezer.
2. Select Type: Press for cubed or crushed ice; water paddle for water.
3. Dispenser Light: Auto-on; toggle if needed.
4. Filter Replacement: Change every 6 months; indicator alerts.
5. Troubleshoot Low Ice: Check water supply, bin not full, temperature.
Note: Discard first ice; do not use non-genuine filters.

Care and Cleaning

1. Interior: Wipe with mild soap and water; dry thoroughly.
2. Shelves/Drawers: Remove and wash; SpillSafe® shelves wipe clean.
3. Exterior: Clean with soft cloth and stainless steel cleaner.
4. Coils: Vacuum every 6 months for efficiency.
5. Filters: Replace water filter every 6 months.
Note: Unplug before deep cleaning; avoid abrasives; use baking soda for odors.

Troubleshooting

• Not Cooling: Check power, settings, seals, vents; ensure level.
  
• No Ice/Water: Verify supply, filter, ice maker on.
  
• Noisy: Normal sounds; level unit; check loose parts.
  
• Odors: Clean interior; use baking soda.
  
• Door Not Closing: Level; adjust hinges.
  
• Light Not Working: Replace bulb (LED compatible).
  Note: For error codes (e.g., SY EF fan failure), reset or consult display; contact 1-800-374-4432 if persists.

Installation Instructions

Warning: Disconnect power before installation. Follow local codes; improper setup may void warranty.

Unpacking and Site Preparation

• Remove from carton; inspect for damage.
  
• Choose location: 1" clearance sides/top, 2" rear; near water line.
  
• Ensure floor supports 350 lbs.
  
• Protect flooring during move.

Leveling and Door Adjustment

1. Adjust Rollers: Turn front leveling screws to raise/lower.
   
2. Check Level: Use bubble level side-to-side and front-to-back.
   
3. Door Alignment: Adjust hinges if misaligned.
   
4. Secure: Ensure stable; doors close properly.

Electrical Connections

• 120V/15A dedicated grounded outlet; no extensions.
  
• Plug directly into wall.
  
• Avoid power strips.

Water Supply Connection

• 1/4" copper tubing; shut-off valve within 6 ft.
  
• Connect to inlet at rear; use compression nut.
  
• 20-120 PSI; flush line before connecting.
  
• Coil excess tubing behind unit.