Frigidaire Refrigerator FFTR1835V Series Operation Manual

The Frigidaire FFTR1835V Series is an 18 cu. ft. top freezer refrigerator engineered for dependable cooling performance, energy efficiency, and ease of use. Featuring adjustable shelving, humidity-controlled crispers, reversible doors, and bright LED lighting, it offers excellent food storage flexibility for everyday households. This manual provides technical specifications, operating instructions, maintenance guidance, and installation steps.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Temperature Control 2.3. Food Storage Tips 2.4. Cleaning and Maintenance 2.5. Troubleshooting 3. Installation Instructions 3.1. Unpacking and Inspection 3.2. Leveling and Positioning 3.3. Electrical Connection 3.4. Door Reversal

Key Specifications

Model: FFTR1835V Series (VW – White, VB – Black, VS – Stainless Steel)
Type: Freestanding top freezer refrigerator
Capacity:
- Total: 18 cu. ft. (510 L)
- Refrigerator: 14.1 cu. ft.
- Freezer: 3.9 cu. ft.
Dimensions: 30 "W × 30-3/8 "D × 66-3/8 "H
Electrical Requirements:
- 120 V / 60 Hz AC
- 15 A dedicated circuit with grounded 3-prong outlet
Energy Use: ENERGY STAR® Certified — approx. 404 kWh per year
Temperature Control: Manual dial thermostat (1 – 7 scale)
Features:
- Humidity-Controlled Crisper Drawers
- Adjustable Glass Shelves
- Reversible Door Swing
- LED Interior Lighting
- Frost-Free Automatic Defrost
- SpillSafe® Shelving

Operation Instructions

Initial Setup

1. Unpack and Inspect: Remove all tape, labels, and packing materials. Check for shipping damage.
2. Level the Unit: Use front adjustable rollers so the refrigerator is level side-to-side and slightly tilted back for self-closing doors.
3. Clean Before Use: Wipe interior with mild soap and warm water, then dry.
4. Power On: Plug into a grounded 120 V outlet. Avoid extension cords.
5. Allow Cooling: Wait at least 4 hours before placing food inside.

Temperature Control

The temperature control knob is located in the fresh-food section and controls both compartments. Settings range from 1 (Warmest) to 7 (Coldest). For typical use, set to **4** and adjust after 24 hours if needed.

Too Warm: Increase to a higher number.
Too Cold: Decrease to a lower number.
Power Outage: Keep doors closed to maintain cold air for up to 12 hours.

Food Storage Tips

Allow space for air circulation between items and interior walls.
Use crisper drawers for fruits and vegetables; adjust humidity as needed.
Store raw meat on lower shelves to avoid cross-contamination.
Keep freezer items sealed to prevent frost buildup.
Avoid blocking vents for best cooling performance.

Cleaning and Maintenance

1. Interior: Clean with mild soap and warm water. Avoid abrasives or ammonia.
2. Exterior: Use a soft cloth with non-abrasive cleaner.
3. Defrost System: Automatic frost-free operation — no manual defrost required.
4. Door Gaskets: Clean monthly to maintain a tight seal.
5. Condenser Coils: Vacuum or brush dust away twice a year.
6. When Not in Use: Unplug, clean interior, and leave doors slightly open to prevent odor.

Troubleshooting

Not Cooling: Check power, thermostat setting, and door seal.
Excessive Noise: Ensure unit is level and not touching walls.
Frost Build-Up: Door may not close fully or gasket is dirty.
Water on Floor: Check drain pan and defrost drain.
Light Not Working: Replace with same type LED bulb.
Door Hard to Open: Vacuum seal after closing is normal; wait a few seconds.

Installation Instructions

Warning: Disconnect power before installation or service. Follow local electrical and plumbing codes.

Unpacking and Inspection

Inspect for shipping damage before discarding packaging.
Verify all accessories (shelves, bins, crispers) are included.

Leveling and Positioning

Place on solid, level flooring.
Adjust front rollers until unit is slightly tilted back for self-closing doors.
Provide at least 1 inch of clearance on sides and top for ventilation.
Do not install near heat sources or in direct sunlight.

Electrical Connection

Use grounded 3-prong outlet only.
Do not remove ground prong or use adapter plugs.
Dedicated 15 A circuit recommended.
Do not use extension cords or power strips.

Door Reversal

Doors are factory-installed for right-hand opening.
To reverse: Remove top hinge cover and screws, move hinges to opposite side, and reinstall plugs.
Verify gasket seal is tight after reversal.