Frigidaire Refrigerator FFTR1835VW Operation Manual

The Frigidaire FFTR1835VW is an 18 cu. ft. top freezer refrigerator designed for reliable, energy-efficient performance. With its flexible interior storage, humidity-controlled crisper drawers, reversible door swing, and bright LED lighting, it provides dependable food preservation for any modern household. This manual covers specifications, operation, maintenance, and installation instructions for safe and efficient use.

1. Key Specifications 2. Operation Instructions 2.1. Initial Setup 2.2. Temperature Control 2.3. Storing Food Properly 2.4. Cleaning and Maintenance 2.5. Troubleshooting 3. Installation Instructions 3.1. Unpacking and Inspection 3.2. Leveling and Positioning 3.3. Electrical Connection 3.4. Door Reversal

Key Specifications

Model: FFTR1835VW (Frigidaire Top Freezer Refrigerator)
Type: Freestanding top-freezer refrigerator
Capacity:
- Total: 18 cu. ft. (510 L)
- Refrigerator: 14.1 cu. ft.
- Freezer: 3.9 cu. ft.
Dimensions: 30" W × 30-3/8" D × 66-3/8" H
Electrical Requirements:
- 120V / 60Hz AC
- Minimum 15A dedicated circuit
- Grounded 3-prong outlet required
Energy Use: ENERGY STAR® Certified; approximately 404 kWh/year
Temperature Control: Manual dial thermostat (1–7 scale)
Features:
- Humidity-Controlled Crisper Drawers
- Adjustable Glass Shelves
- Bright LED Lighting
- Reversible Door Swing
- SpillSafe® Shelving
- Frost-Free Defrost System

Operation Instructions

Initial Setup

1. Remove Packaging: Unpack refrigerator and remove all tape, labels, and packing materials.
2. Level the Unit: Use adjustable front rollers to ensure the refrigerator is level from side to side and front to back.
3. Clean Interior: Wipe shelves and walls with mild detergent and warm water before loading food.
4. Plug In: Connect to a grounded 120V outlet. Do not use extension cords.
5. Allow Cooling Time: Let the refrigerator run for at least 4 hours before placing food inside.

Temperature Control

The control dial inside the refrigerator compartment regulates both the fridge and freezer sections. Settings range from 1 (Warmest) to 7 (Coldest). For normal operation, set the control to **4**. Adjust as needed after 24 hours based on food temperature.

Too warm: Increase setting to a higher number.
Too cold: Decrease setting to a lower number.
Power outage: Keep doors closed; food stays cold up to 12 hours.

Storing Food Properly

Allow air circulation by not blocking vents.
Store raw meat on lower shelves to prevent dripping.
Use crisper drawers for fruits and vegetables; adjust humidity as needed.
Do not overload the door bins; heavier items should go on shelves.
Keep freezer items sealed to avoid frost buildup.

Cleaning and Maintenance

1. Interior Cleaning: Wipe with mild soap and warm water. Avoid harsh chemicals or abrasives.
2. Exterior Cleaning: Use soft cloth with non-abrasive cleaner. Stainless steel cleaner recommended for trim surfaces.
3. Defrosting: Frost-free system; no manual defrost required.
4. Door Gasket: Clean with warm, soapy water to maintain a tight seal.
5. Condenser Coils: Vacuum dust from coils at least twice per year.
6. When Not in Use: Unplug, clean interior, and leave doors slightly open to prevent odor.

Troubleshooting

Not cooling: Check power connection and thermostat setting.
Excessive noise: Ensure refrigerator is level and not touching walls.
Frost buildup: Door not closing properly or gasket damaged.
Water on floor: Check drain pan and defrost drain tube.
Light not working: Replace LED bulb with same type and rating.
Door difficult to open: Normal vacuum effect after closing; wait a few seconds before reopening.

Installation Instructions

Warning: Always disconnect power before installation or maintenance. Install according to local codes and safety standards.

Unpacking and Inspection

Inspect for any visible damage during transport.
Keep packaging until installation is complete.
Check that all shelves, bins, and accessories are included.

Leveling and Positioning

Place refrigerator on a flat, stable surface.
Adjust leveling legs so the front is slightly higher for proper door closure.
Allow at least 1 inch clearance on each side and top for ventilation.
Do not install near ovens, radiators, or direct sunlight.

Electrical Connection

Use grounded 3-prong outlet only.
Do not remove ground prong or use adapter.
Dedicated 15A circuit recommended.
Do not use extension cords.

Door Reversal

Door swing is factory-installed for right-hand opening.
To reverse: Remove top hinge cover and screws, switch hinges to opposite side, reinstall plugs and caps.
Ensure gasket seals properly after door reversal.